Now add New Bridge Port, select Interface: Vlan-10 and select Bridge: Bridge-Vlan-10 and click on “OK”.
Click on “Bridge” and select “Ports” tab. H) Now add interfaces in the designated bridge. G) Similarly add now bridge for VLAN ID 20. Bridge-Vlan-10) and click on “OK” to create the bridge. Click on “Bridge”.į) Now add bridge (i.e. Vlan Interface – Vlan-20 Vlan Interface ListĮ) Now we have to create a bridge for VLAN ID 10. Vlan Interface – Vlan-10ĭ) Similarly now add another Vlan-20, just like previous step. “ether1”) and then click on “OK” to create a VLAN Interface.
10) and select interface, which will become the trunk (I.e. Click on “Interfaces” and select “VLAN” tab.Ĭ) Now add vlan interfaces, type Name (i.e. Step 1 – Configure Trunk and Access Ports on Cisco – Catalyst 2960Ī) Use the following commands to configure Cisco – Catalyst 2960:Ģ960(config)#interface gigabitEthernet 1/2Ģ960(config-if)#switchport trunk allowed vlan add 10Ģ960(config-if)#switchport trunk allowed vlan add 20Ģ960(config-if)#switchport access vlan 10Ģ960(config-if)#switchport access vlan 20Ģ960(config-if)#end Step 2 – Configure Trunk and Access Ports on Mikrotik – RB750ī) Now will create the VLAN interfaces (i.e. Configure Trunk and Access Ports on Mikrotik – RB750.Configure Trunk and Access Ports on Cisco – Catalyst 2960.We will perform the following steps to create this solution: Below is the scenario: Scenario – Configure Mikrotik – RB750 as a Switch
So in this guide, I will share my experience. Finally I found one link which fulfilled my requirement and is mentioned in “References”. I did not find much help to satisfy my requirements. I had a requirement that I wanted to use the Mikrotik as a Switch with a Trunk and Multiple Vlans and each Vlan assigned to different Ports.